[Zope] pcgi fails with only included python

[Albert Kinderman]

I just did a fresh install of Zope 2.0 on a new RedHat 6.0 system. 
Using apache, the Zope.cgi failed with a connection refused (102)
failure during connect from pcgi-wrapper.

Zope.cgi points to /usr/local/Zope/bin/python as the PCGI_EXE, which
should be 1.5.2 as required.  However, the installed python on RedHat
6.0 was 1.5.1.  

After I updated the python on the system to 1.5.2, Zope.cgi worked.  I
had a similar problem before when the system had no python on it.  [I
should have remembered sooner that the problem was probably the python
version.]

Is it possible to configure pcgi-wrapper to run correctly with only
Zope/bin/python installed on the system?

Al


-- 
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
Albert Kinderman              California State University, Northridge
albert.kinderman@csun.edu     Department of Managment Science