[Zope] how to enable Large File Support with 2.5 release?

[seb bacon]

Incidentally the method mentioned on python.org for enabling LFS doesn't
work; adding the following to config.h does, however:

  #define LARGEFILE_SOURCE 1

  #define _FILE_OFFSET_BITS 64

And don't forget to ./configure --without-pymalloc and --with-threads,
too.

seb

On Wed, 2002-02-06 at 17:44, Andreas Jung wrote:
> compilesz.py only byte-compiles the .py files but does has
> nothing to do with the built-in LFS support. So your solution
> is to grab the Python sources, check how to enable LFS support
> (at least for 2.1.X) and then compile and install it.
> 
> -aj
> 
> ----- Original Message -----
> From: "marc lindahl" <marc@bowery.com>
> To: "Andreas Jung" <andreas@zope.com>; <zope@zope.org>
> Sent: Thursday, February 07, 2002 13:43
> Subject: Re: [Zope] how to enable Large File Support with 2.5 release?
> 
> 
> > Doesn't compilezpy.py make the python binary when you install?  (also, for
> > future, I noticed that python 2.2 is supposed to auto-detect during
> build?)
> >
> > > From: "Andreas Jung" <andreas@zope.com>
> > > Organization: Zope Corporation
> > > Reply-To: "Andreas Jung" <andreas@zope.com>
> > > Date: Wed, 6 Feb 2002 12:31:18 -0500
> > > To: "marc lindahl" <marc@bowery.com>, <zope@zope.org>
> > > Subject: Re: [Zope] how to enable Large File Support with 2.5 release?
> > >
> > > You have to build Python from scratch because LFS depends
> > > on your operating system and a pre-built Python binary
> > > with LFS enabled might not run on a system that has
> > > no LFS support.
> > >
> > > - aj
> > >
> > >
> >
> >
> 
> 
> _______________________________________________
> Zope maillist  -  Zope@zope.org
> http://lists.zope.org/mailman/listinfo/zope
> **   No cross posts or HTML encoding!  **
> (Related lists - 
>  http://lists.zope.org/mailman/listinfo/zope-announce
>  http://lists.zope.org/mailman/listinfo/zope-dev )