[Zope] Re: [Zope-dev] The number of threads in z2.py file.

[Josef Meile]

> i'm using Zope-2.6.3, Red Hat-8.0, CMF-1.4.2, and
> CMFPlone-2.0-RC3. If the number of threads=4, the zope
> can start but cannot load into ZMI. After i change the
> number of threads=1, it can load into ZMI. Why?
It could be that when you compiled your python, you
didn't configure it to use threads (I'm not sure if 2.1.3
does this by default). However, before installing python again,
you had better to check the log as Dieter said. Perhaps it's
another problem.

Regards,
Josef